Rule-Mate 2000 GPH 12 Volt Fully Automated Bilge Pump

The Rule-Mate® 2000 GPH pump consists of a powerful Rule® bilge pump and a highly intelligent circuit board in a single housing. The pump activated when the water reaches 2-1/2" and automatically shuts off when the pump senses no water against the impeller, reducing the remaining water to approximately 5/8".

Rule-Mate Intelligence
Rule-Mate Bilge pumps have built-in programming that can sense when the pump is running but not pumping water. This is a very unique feature to bilge pumps because it protects the pump and the vessel, especially the vessels batteries. If debris fouls the sensor or the pump becomes air-bound, the pump will stop running and begin to "check" for water every 2-1/2 minutes. Once the debris is removed, the pump will revert to its normal operation, turning on when the water reaches 2-1/2" and shutting off at 5/8".

• 2000 GPH (7570 LPH) at 0' (13.6V)
  
• All-in-one pump and switch
  
• Extra long life heavy duty motor
  
• 1" NPS discharge with 1" AND 1 1/8" screw-on ports
  
• Three year warranty

WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.