MM1-DST-10F Mix and Match™ Furuno 10-Pin Cable

Mix and Match 1kW transducers are made as a common base transducer with a short (2m) cable attached, plus an interchangeable longer (8m) brand-specific adapter cable. The short pigtail attached to the transducer ends in an Airmar 9-pin male connector. The adapter cables have a matching Airmar 9-pin female connector at one end and the correct connector for a specific brand of electronics at the other end.

Both parts are needed for an installation. If the user changes equipment brand at some later time, the transducer can be left in place and the adapter cable replaced.

Note: 1kW Mix and Match cables cannot be used with 600W transducers or CHIRP transducers.

WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.