500GPH Electronic Sensing Bilge Pump - 12V

In the next generation sensing bilge pumps, the 500GPH S series pump works on the principle of impeller resistance. The pump will turn on every 2-1/2 minutes for about one second to sense for water. If water is present, the pump will sense resistance and continue to run until all water is removed. After that, it will resume checking for water every 2-1/2 minutes.

Water is kept in check between 1/8" and 3/8"!!! Great idea when power conservation is needed and as an added benefit, no float switch is needed!

All that plus the added benefits of our standard bilge pump:

• Check valve included with hidden air vent to prevent airlocking
  
• True electromagnetic suppression (EMC)
  
• A built-in thermal cell that protects the pump and the vessel when things get too hot

• Completely automatic with manual override - No Float Switch Needed!
  
• Submersible and Ignition Protected
  
• High efficiency, low amp motor
  
• Stainless-steel shaft
  
• Includes backflow preventer

WARNING: This product can expose you to chemicals including 1,3-Butadiene which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.